Repair or replace Chord Qutest with same or something different?

MikeCh

Active member
Joined
Nov 25, 2013
Messages
1,985
Location
Colorado
Hi All,

A little background. I purchased a Chord Qutest in late 2018 and it worked famously for my needs until mid 2020 when it failed with a motor-boating sound and diminished volume no matter the input selection. I contacted Chord UK and they asked me to send it to George Meyer repair in California for which, Chord authorized and paid for the repair work. The main board was replaced and the unit returned to me.

I then ran the Qutest (it's powered on 24/7/365 unless we're gone for extended periods or thunder storms are eminent then the whole system is unplugged from mains power) until Oct 2024 when the same issue arose (motor-boating and diminished volume no matter the input selection) so I contacted George Meyer once again and sent it in for repair. Same diagnosis, main board needed to be replaced. This time it cost me just under $800 all in.

This got me to thinking..."what am I doing to this thing?"...over heating, maybe.? It had been sitting atop my cable TV box on the top of my gear rack and noticed that it does get a little warm, not hot by any means. So, when this second repaired effort came back, I relocated the Qutest adjacent to the cable TV box and elevated it on two of those HVAC cork/rubber isolation squares (standing on edge) to raise the Qutest so it had 2" of air beneath it. That solved any kind of heat issues and the Qutest ran at room temperature since Oct 2024....until just recently.

Today I went to listen to some tunes and found that once again the Qutest is exhibiting that "motor-boating and diminished volume no matter the input selection" behavior. I'm baffled. Do I send it back in for a third, $800 repair? Do I go buy a different Qutest (because I really love the sound and flexibility it brings to the system as a whole between adjustable gain, adjustable EQ curves and the input type options) or do I throw in the towel and go find something else that will be it's equal to my ears and connection needs?

I can't really justify spending more than $2500 on a DAC at this point. Wondering what to do...

Your thoughts?

Thanks,
Mike
 
Last edited:
I think with the time that past and a continuing problem I'd move on. A shame they aren't able to eliminate the defect. It would be interesting to know if this is an issue for others. If so, the company should have taken better care of you.

You might look at Schiit who offers a decent DAC for the same cost of your repair or an excellent at $2500, the Yggy.

I'm not sure what all you are using the Chord for the Teac 500 series DAC's are excellent and perform beyond their range. Same for the 700 series at more money. I mean they are impressive.

No shortage of DAC options.
 
Too many DACs to continue fussing with one that cost $800 for repairs on a regular basis. Pick a price point, and a flavor, you will find something you like.
 
Guys, Thanks for the confirmation of what I've been thinking myself....move on.
The fact that they only doing board swaps makes repairs expensive when it’s probably an inexpensive part that failed. Electrolytic capacitors are a prime suspect.

I’ll second the Yggdrasil recommendation. Excellent sounding DAC, made and serviced in the US. It’s modular and upgradable. For example I added their latest USB interface for $125 several years ago.
 
The fact that they only doing board swaps makes repairs expensive when it’s probably an inexpensive part that failed. Electrolytic capacitors are a prime suspect.

I’ll second the Yggdrasil recommendation. Excellent sounding DAC, made and serviced in the US. It’s modular and upgradable. For example I added their latest USB interface for $125 several years ago.

From what I understand they even have like 3 versions to chose from.
 
I took your advice Mr. Peabody and Tom.

The Yggdrasil+ Singular is/was tempting, but I found what appears to be a lightly used Yggdrasil+ LIM and decided to step into the Schiit pool this way for now. Looking forward to its arrival. If the LIM isn't a match, I may well try the Singular down the road. Thank you for reminding me of Schiit's products.
 
I took your advice Mr. Peabody and Tom.

The Yggdrasil+ Singular is/was tempting, but I found what appears to be a lightly used Yggdrasil+ LIM and decided to step into the Schiit pool this way for now. Looking forward to its arrival. If the LIM isn't a match, I may well try the Singular down the road. Thank you for reminding me of Schiit's products.
I haven't heard that unit myself but I've heard many positive comments.

Keep up updated and let us know how it works out for you!
 
I took your advice Mr. Peabody and Tom.

The Yggdrasil+ Singular is/was tempting, but I found what appears to be a lightly used Yggdrasil+ LIM and decided to step into the Schiit pool this way for now. Looking forward to its arrival. If the LIM isn't a match, I may well try the Singular down the road. Thank you for reminding me of Schiit's products.
Let us know how it works out. I’ve had my Yggy for about 7 years now. You can probably upgrade to the singular at a later date if you choose. Sometimes it is a simple board swap, other times it’s almost a complete factory change out.

One note, keep your Yggy plugged in and on all the time. Mine takes a day to stabilize when I turn it off, like when we are on vacation.
 
Let us know how it works out. I’ve had my Yggy for about 7 years now. You can probably upgrade to the singular at a later date if you choose. Sometimes it is a simple board swap, other times it’s almost a complete factory change out.

One note, keep your Yggy plugged in and on all the time. Mine takes a day to stabilize when I turn it off, like when we are on vacation.

Appreciate the info, Tom. Will post my thoughts once I get some time with it. Thanks again.
 
Quick update. I've had the Schiit Yggdrasil+ LIM in my setup for a couple weeks now. It's a great piece of kit. The sound is extremely pleasant. Maybe just a bit too pleasant? I find that at the lower volume levels that I generally listen, it might be just a tad dark sounding. At increased listening volume levels, it is sublime and feels just right, no darkness whatsoever!

If anyone is familiar with the Chord Qutest, it has four different "filter options" to slightly change the sonic output signature and the Yggdrasil reminds me most of the "orange" setting described below. When I had the Qutest, I generally listened with the "green" setting:

From google AI:

The Chord Qutest DAC features four user-selectable digital frequency-shaping filters accessible via the front-mounted spherical control buttons:
  • Incisive Neutral (White): Delivers maximum timing precision, transparency, and a clean, detailed presentation.
  • Incisive Neutral with High-Frequency Roll-Off (Green): Applies the same transparent baseline but softens the extreme top end slightly to reduce brightness, dryness, or out-of-band noise.
  • Warm (Orange): Introduces a subtle organic warmth, adding body and richness to the sonic profile.
  • Warm with High-Frequency Roll-Off (Red): Combines the added midrange/body warmth with the high-frequency roll-off for the smoothest, most forgiving presentation—ideal for taming aggressive or poorly mastered recordings.

I lucked out, I'd contacted Chord UK right after my Qutest died again and they had me send it the US distributor for evaluation. They checked it out and couldn't find anything wrong with the PCB or PSU and Chord UK decided to replace the PCB and PSU regardless. I am VERY grateful that they have done this for me. The rebuilt Qutest should be back in my hands early this coming week so I'll now get a chance to do a head to head comparison with the Yggdrasil. Yay!

Not sure which one I'll end up enjoying the best, but it should be interesting to compare them. I really like the fact that the Yggdrasil is US made and apparently very reliable, upgradeable and serviceable.

Cheers,

Mike
 
Quick update. I've had the Schiit Yggdrasil+ LIM in my setup for a couple weeks now. It's a great piece of kit. The sound is extremely pleasant. Maybe just a bit too pleasant? I find that at the lower volume levels that I generally listen, it might be just a tad dark sounding. At increased listening volume levels, it is sublime and feels just right, no darkness whatsoever!

If anyone is familiar with the Chord Qutest, it has four different "filter options" to slightly change the sonic output signature and the Yggdrasil reminds me most of the "orange" setting described below. When I had the Qutest, I generally listened with the "green" setting:

From google AI:

The Chord Qutest DAC features four user-selectable digital frequency-shaping filters accessible via the front-mounted spherical control buttons:
  • Incisive Neutral (White): Delivers maximum timing precision, transparency, and a clean, detailed presentation.
  • Incisive Neutral with High-Frequency Roll-Off (Green): Applies the same transparent baseline but softens the extreme top end slightly to reduce brightness, dryness, or out-of-band noise.
  • Warm (Orange): Introduces a subtle organic warmth, adding body and richness to the sonic profile.
  • Warm with High-Frequency Roll-Off (Red): Combines the added midrange/body warmth with the high-frequency roll-off for the smoothest, most forgiving presentation—ideal for taming aggressive or poorly mastered recordings.

I lucked out, I'd contacted Chord UK right after my Qutest died again and they had me send it the US distributor for evaluation. They checked it out and couldn't find anything wrong with the PCB or PSU and Chord UK decided to replace the PCB and PSU regardless. I am VERY grateful that they have done this for me. The rebuilt Qutest should be back in my hands early this coming week so I'll now get a chance to do a head to head comparison with the Yggdrasil. Yay!

Not sure which one I'll end up enjoying the best, but it should be interesting to compare them. I really like the fact that the Yggdrasil is US made and apparently very reliable, upgradeable and serviceable.

Cheers,

Mike

I'm not the Schiit expert from what I understand there are a few versions of that DAC, you might look into the differences to see if another version might be more to your taste.

Glad they fixed the Chord but you have to love it when you send in something for repair and you get the nothing wrong with it line, but we'll fix it anyway.
 
Sorry Mr. Peabody, I didn't explain the situation with the Qutest very well. The distributor examined my Qutest and found that it was exhibiting the same problems as I had described here when testing in-house in their shop. What I meant by "they couldn't find anything wrong with it" was that they told me they couldn't find an obvious failure point (over temp / over voltage / etc.) that could have caused the failure. So, they did what has always been done since the unit only has one "part"...the PCB, and replaced the PCB again but did a very thorough series of tests on it before clearing it for the return shipment back to me.

All I can say is, Thank you to them and it does give me the opportunity to compare it to the Yggdrasil. We will see!

Cheers,
Mike
 
Quick update. I've had the Schiit Yggdrasil+ LIM in my setup for a couple weeks now. It's a great piece of kit. The sound is extremely pleasant. Maybe just a bit too pleasant? I find that at the lower volume levels that I generally listen, it might be just a tad dark sounding. At increased listening volume levels, it is sublime and feels just right, no darkness whatsoever!

If anyone is familiar with the Chord Qutest, it has four different "filter options" to slightly change the sonic output signature and the Yggdrasil reminds me most of the "orange" setting described below. When I had the Qutest, I generally listened with the "green" setting:

From google AI:

The Chord Qutest DAC features four user-selectable digital frequency-shaping filters accessible via the front-mounted spherical control buttons:
  • Incisive Neutral (White): Delivers maximum timing precision, transparency, and a clean, detailed presentation.
  • Incisive Neutral with High-Frequency Roll-Off (Green): Applies the same transparent baseline but softens the extreme top end slightly to reduce brightness, dryness, or out-of-band noise.
  • Warm (Orange): Introduces a subtle organic warmth, adding body and richness to the sonic profile.
  • Warm with High-Frequency Roll-Off (Red): Combines the added midrange/body warmth with the high-frequency roll-off for the smoothest, most forgiving presentation—ideal for taming aggressive or poorly mastered recordings.

I lucked out, I'd contacted Chord UK right after my Qutest died again and they had me send it the US distributor for evaluation. They checked it out and couldn't find anything wrong with the PCB or PSU and Chord UK decided to replace the PCB and PSU regardless. I am VERY grateful that they have done this for me. The rebuilt Qutest should be back in my hands early this coming week so I'll now get a chance to do a head to head comparison with the Yggdrasil. Yay!

Not sure which one I'll end up enjoying the best, but it should be interesting to compare them. I really like the fact that the Yggdrasil is US made and apparently very reliable, upgradeable and serviceable.

Cheers,

Mike
Great feedback Mike. I heard this DAC at MadFloyd’s (Ian’s) and it beat his dcs
 
Back
Top