Dman777dman777
Member
- Thread Author
- #1
Background:
I have 2 dedicated lines/2 breakers that go to my circuitbreaker box (interior). Since the interior is fed by the exterior box I imagine it might still get the Air Conditioner feedback. I checked with a digital meter and my power flucerations are minor and well with in range.
I noticed on weeknights my systems will sound crytal clear with a back background. But in the daytime or weekends not so much.
I am debating... I will ether buy a used Shunyata Everest and Omega XC cable (non X versions for both) or a new Eiger X with Sigma X cable. My house is small so I will never upgrade to monoblocks. Which would be best for my set up?
Note: I have 2 amps and I switch between them on weekdays and weekends.
On the weekdays:
Moon 861 Amp - Audio Output Efficiency Calculation: Driven to its maximum rated continuous stereo output (600 W per channel into 4 Ω = 1,200 W RMS total), a high-bias Class A/AB amplifier operating at typical ~65% efficiency draws approximately 1,700 W to 1,800 W continuously from the wall.
Instantaneous Peak Demand: The 3,000 VA transformer bank and 228,000 µF reservoir are designed to pull instantaneous, unconstrained current bursts exceeding 2,500 W to 3,000 W
-------------------
Rel sub s/812 - ~100 Watts average during dynamic bass passages (800W peak transient).
------------------
Techniques 1200g - 14 W
-----------------------
Yamaha RN-2000A used as a preamp to the Moon - Max 350W
---------------------
lumin u2x - 30W
----------------
Dave Chord - 30W
On weekends:
Luxman 595 Integrated Class A amp - 330 Watts continuous maximum draw.
---------------------
Rel sub s/812 - ~100 Watts average during dynamic bass passages (800W peak transient).
------------------
Techniques 1200g - 14 W
-----------------------
lumin u2x - 30W
----------------
Dave Chord - 30W
I have 2 dedicated lines/2 breakers that go to my circuitbreaker box (interior). Since the interior is fed by the exterior box I imagine it might still get the Air Conditioner feedback. I checked with a digital meter and my power flucerations are minor and well with in range.
I noticed on weeknights my systems will sound crytal clear with a back background. But in the daytime or weekends not so much.
I am debating... I will ether buy a used Shunyata Everest and Omega XC cable (non X versions for both) or a new Eiger X with Sigma X cable. My house is small so I will never upgrade to monoblocks. Which would be best for my set up?
Note: I have 2 amps and I switch between them on weekdays and weekends.
On the weekdays:
Moon 861 Amp - Audio Output Efficiency Calculation: Driven to its maximum rated continuous stereo output (600 W per channel into 4 Ω = 1,200 W RMS total), a high-bias Class A/AB amplifier operating at typical ~65% efficiency draws approximately 1,700 W to 1,800 W continuously from the wall.
Instantaneous Peak Demand: The 3,000 VA transformer bank and 228,000 µF reservoir are designed to pull instantaneous, unconstrained current bursts exceeding 2,500 W to 3,000 W
-------------------
Rel sub s/812 - ~100 Watts average during dynamic bass passages (800W peak transient).
------------------
Techniques 1200g - 14 W
-----------------------
Yamaha RN-2000A used as a preamp to the Moon - Max 350W
---------------------
lumin u2x - 30W
----------------
Dave Chord - 30W
On weekends:
Luxman 595 Integrated Class A amp - 330 Watts continuous maximum draw.
---------------------
Rel sub s/812 - ~100 Watts average during dynamic bass passages (800W peak transient).
------------------
Techniques 1200g - 14 W
-----------------------
lumin u2x - 30W
----------------
Dave Chord - 30W
