Bias for ATM-4 : easy or not ? Thanks

H

hongkong

Member
Joined
Oct 25, 2015
Messages
357
Location
FRANCE
Hello,

I would know if the Bias for ATM-4 is easy or not ? Thanks.

I have found for ATM-1, setup must be all 50 hours...

Best regards
 
Mine is ATM3 and it's super easy to do. Just open the panel on the front and use any flat driver to adjust it. Adjust the needle in the bubble zone you are all done. Note : Make sure you turn down the volume attenuator knob while you are adjusting it.

This is ATM4 front panel
b.jpg
 
Paul said:
Mine is ATM3 and it's super easy to do. Just open the panel on the front and use any flat driver to adjust it. Adjust the needle in the bubble zone you are all done. Note : Make sure you turn down the volume attenuator knob while you are adjusting it.

This is ATM4 front panel
b.jpg
Click to expand...

Hi Paul, thank you very much. Do you come with us in Munich ? Best regards.
I have a good price for buy two Air Tight ATM-4 but my preamplifier is with XLR and ATM-4 with RCA. So I have adapter Neutrik but I ask me if it is a good solution ?
Your ATM-3 is with XLR or RCA ?
 
hongkong said:
Hi Paul, thank you very much. Do you come with us in Munich ? Best regards.
I have a good price for buy two Air Tight ATM-4 but my preamplifier is with XLR and ATM-4 with RCA. So I have adapter Neutrik but I ask me if it is a good solution ?
Your ATM-3 is with XLR or RCA ?
Click to expand...

I only have single end input and output. NO XLR available on mine.
 
You must log in or register to reply here.
Back
Top