T+A firmware update

We have just released new firmware for the following T+A devices:
Cala
MP1000 E
R1000 E
MP2000 R MkII
MP2500 R
MP3100HV
SD3100
SDV3100
MP 8

In order to solve the problems that occurred after this weeks roon update as quick as possible we have decided to make this new firmware instantly available as a beta release via web-update.
The next stable firmware release will be released after thorough testing in the course of the next week.
In order to install the latest beta firmware release, please proceed as follows (the process is identical for all T+A devices):

1.) make sure that your T+A device is connected to the internet.
2.) switch ON your device and wait until the streaming client is up and running
3.) press the SYS button of your remote control to enter the System Setup menu
4.) navigate to the “DEVICE INFO” menu item at the bottom of the list
5.) press “OK”
6.) navigate to the “UPDATE” menu item
7.) press “OK”
8.) with the Cursor_Left / Cursor_Right buttons select “WEB(Beta)”
9.) press “OK”
10.) the message “start WEB(B) update” will appear
11.) press “OK” again
12.) “start WEB(B) update” will get highlighted
13.) press “OK” again
14.) now a message “Please wait” will appear - the update process has begun.

Now please wait until the update process has completed - this may last several minutes - please be patient. The device will automatically switch OFF after the update has finished.
You can now switch the device ON again.

To check if the update was successful you can again enter the System Menu with the SYS button.
Navigate down to “Device Info” and press “OK”. Navigate down to the “Client” menu item. The client version should now be displayed as “V1.1.6c”.

After this firmware update roon should be working again…

Sent from my iPhone using Tapatalk